The correct way to use the traction bed


Release time:

2022-02-27

Traction bed is also called medical traction bed, is the hospital in the treatment of cervical spondylosis lumbar disease commonly used medical equipment, its use method is not complicated, but there are certain methods and skills, and for different patients, it has different methods of use. When using the traction bed, you can separate the two sides of the traction belt on it and tie it on the head of the bed at both ends, or you can connect the traction belt with a rope.

Traction bed is also called medical traction bed, is the hospital in the treatment of cervical spondylosis lumbar disease commonly used medical equipment, its use method is not complicated, but there are certain methods and skills, and for different patients, it has different methods of use. When using the traction bed, you can separate the two sides of the traction belt on it and tie it on the head of the bed at both ends, or you can connect the traction belt with a rope.

When using the traction bed, the patient should lie on the bed and tie the two traction belts to his waist and chest respectively. The body should be extended upward as much as possible. In the process of extension, the traction belt should be tightened and the length of the belt tied to the head of the bed must be consistent, otherwise the patient's body will lose balance. After the patient is fixed, when the handwheels on both sides are pulled with both hands, the bed surface of the traction bed is slowly separated and pulled apart. This speed must be slow. The patient should slowly accept the traction force. It is more appropriate for the patient to bear it. Excessive force cannot be used, otherwise strain will occur and the patient's condition will worsen.
The use time of traction bed has certain regulations. Under normal circumstances, the time for patients to receive traction treatment should be between 20 and 30 minutes each time. One time should not be too long, otherwise it will be harmful to health. In addition, the treatment cycle should be formulated according to the patient's condition. In clinical practice, most patients will be treated. Each course of 1-2 courses is 10-15 days. After the traction bed is used, it should be shaken back in the opposite direction to allow the traction bed to return to its normal state. At this time, patients should not leave the traction bed in a hurry and should rest in bed for half an hour to ensure the effect of traction treatment.
After using the traction bed for treatment, patients often have adverse symptoms such as acid, sleepness, discomfort and pain. After half an hour of bed rest, there will be moderate relief. After the symptoms are relieved, gently get up from the bed and move slowly. Do not do strenuous exercise, let alone squat violently. Give cervical and lumbar vertebrae a recovery time, which will slowly reduce the condition. After a period of treatment, the disease can basically recover. The structure is simple, but it is a professional medical device. Many people want to operate the traction bed at home, but this is risky. Therefore, when doing traction, try to go to a professional hospital and use the traction bed under the supervision of a doctor. In this way, when accidents or strong physical discomfort occur again, the doctor can deal with them as soon as possible to avoid serious harm to the patient's body.
When patients use traction bed for treatment, they should have a gradual process. When they start to accept traction, they have poor ability to accept traction and always feel special pain. At this time, they should let their bodies slowly adapt to not blindly exerting force. They should try their best to gradually increase the traction of traction bed. For the first time, they can be slightly smaller, and for the second time, they should be appropriately increased until the patient's bearing capacity is more appropriate, only by insisting on doing so can good therapeutic effects appear.

Key words: